I use D90. When I look back the picture on LCD after taken, it is ok, but when the printed photo, it is not as sharp and bright as those watched on LCD. why? and how should I set the camera so as to ensure thatn the printed photo is as sharp and bright as those shown on LCD?
原帖由 PSP1999 於 09-7-27 21:19 發表
I use D90. When I look back the picture on LCD after taken, it is ok, but when the printed photo, it is not as sharp and bright as those watched on LCD. why? and how should I set the camera so as to ...
Apart from those out of focus, when I watch the picture through the LCD, it is bright and the colour is sharp, but when it is a photo, both brightness and colour are bit weakened.
原帖由 PSP1999 於 09-7-27 22:48 發表
Apart from those out of focus, when I watch the picture through the LCD, it is bright and the colour is sharp, but when it is a photo, both brightness and colour are bit weakened.
If you print by yourself, is it the printer don't support such high resolution?
If oyu printed outside, normally, they will tune your pic before printing... don't whether it affects the quality.....
原帖由 PSP1999 於 09-7-27 22:48 發表
Apart from those out of focus, when I watch the picture through the LCD, it is bright and the colour is sharp, but when it is a photo, both brightness and colour are bit weakened.
原帖由 PSP1999 於 09-7-28 16:22 發表
I use SRGB and the photos were developed outside and at the same shop. May be next time, I will try another one to see there is any different.